TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(a) Turn engine start and battery
2347 06 - Continued.
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Ride control solenoid valve #2 remains
disconnected from wiring harness.
(c) Disconnect wiring harness
connector(s) from powertrain ECM
(WP 0063 00).
(d) At wiring harness connector for ECM, 1. If each resistance is greater than 5,000
measure resistance from J2-6 (wire
Ohms, go to Test 3.
N936-YL) to all contacts used in wiring 2. If each resistance measurement is not
harness connectors for ECM.
greater than 5,000 Ohms, short is
between signal circuit for ride control
solenoid valve #2 and circuit with low
resistance measurement. Replace
wiring harness in question (WP 0195 00
thru WP 0201 00).
3. Check if diagnostic code remains active.
(a) Inspect and clean wiring harness
connector contacts.
(b) Reconnect all wiring harness
connectors.
(c) Operate machine (TM 5-3805-291-
10).
(d) Check status of CID 2347 FMI 06.
1. If CID 2347 FMI 06 is active, exit this
procedure and repeat this procedure. If
cause of diagnostic code is not found,
replace powertrain ECM (WP 0063 00).
2. If CID 2347 FMI 06 is not active,
diagnostic code does not exist at this
time. Resume normal machine
operation.
0009 00-155
