TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(a) Turn engine start and battery
2347 03 - Continued.
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Ride control solenoid valve #2 remains
disconnected from wiring harness.
(c) Disconnect wiring harness
connector(s) from powertrain ECM
(WP 0063 00).
(d) At wiring harness connector for ECM,
1. If each resistance measurement is
measure resistance from contact J2-6
greater than 5,000 Ohms, go to Test 3.
(wire N936-YL) to all contacts used in
2. If each resistance measurement is not
wiring harness connectors for ECM.
greater than 5,000 Ohms, short is
between J2-6 and circuit with low
resistance measurement. Replace
wiring harness in question (WP 0195 00
thru WP 0201 00).
3. Check if diagnostic code remains active.
(a) Inspect and clean wiring harness
connector contacts.
(b) Reconnect all wiring harness
connectors.
(c) Operate machine (TM 5-3805-291-
10).
(d) Determine if CID 2347 FMI 03 is
1. IF CID 2347 FMI 03 is active, exit this
active.
procedure and repeat this procedure. If
the cause of diagnostic code is not
found, replace powertrain ECM (WP
0063 00).
2. If CID 2347 FMI 03 is not active,
problem does not exist at this time.
Resume normal machine operation.
0009 00-151
