TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2347 06
427-C1641
N OT E
The following test procedure may create other diagnostic codes. Ignore
these created diagnostic codes and clear these diagnostic codes when
original diagnostic code is corrected. Ensure diagnostic code CID 2347
FMI 06 is active before performing this procedure.
1. Check solenoid.
(a) Turn battery disconnect and engine
start switches to ON position. Do not
start engine (TM 5-3805-291-10).
(b) Disconnect ride control solenoid valve
#2 from wiring harness.
(c) At wiring harness connector for
solenoid, place a jumper wire from
contact 2 to contact 1.
(d) Connect MSD (WP 0005 00) and
1. If diagnostic code remains active, go to
observe status of CID 2347 FMI 06.
Test 2.
2. If diagnostic code is not active, solenoid
has failed. Repeat this test to verify
solenoid failure. Replace main control
valve (WP 0218 00). Verify new
solenoid corrects problem.
2. Check solenoid energizer circuit for a short
to ground.