TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(b) Ride control solenoid valve #2 remains
2347 05 - Continued.
disconnected from wiring harness.
(c) Disconnect wiring harness
connector(s) from powertrain ECM
(WP 0063 00).
(d) At wiring harness connector for ride
control solenoid valve #2, place a
jumper wire from contact 2 to contact 1.
(e) At wiring harness connector for ECM,
1. If resistance is less than 5.0 Ohms, go to
measure resistance from J2-6 (wire
Test 3.
N936-YL) to contact J2-4 (wire J815-
2. If resistance is greater than 5,000 Ohms,
BK).
open circuit is in wire N939-GN or in
J815-BK. Replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
3. Check if diagnostic code remains active.
(a) Inspect and clean wiring harness
connector contacts.
(b) Reconnect all wiring harness
connectors.
(c) Operate machine (TM 5-3805-291-
10).
(d) Determine if CID 2347 FMI 05 is
1. If CID 2347 FMI 05 is active, problem
active.
has not been corrected. Exit this
procedure and repeat this procedure. If
cause of diagnostic code is not found,
replace powertrain ECM (WP 0063 00).
2. If CID 2347 FMI 05 is not active,
problem does not exist at this time.
Resume normal machine operation.
0009 00-153