TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2347 03
427-C1641
N OT E
The following test procedure may create other diagnostic codes. Ignore
these created diagnostic codes and clear these diagnostic codes when the
original diagnostic code is corrected. Ensure diagnostic code CID 2347
FMI 03 is active before performing this procedure.
1. Check solenoid.
(a) Turn battery disconnect and engine
start switches to ON position. Do not
start engine (TM 5-3805-291-10).
(b) Disconnect ride control solenoid valve
#2 from the wiring harness (WP 0218
00).
(c) At wiring harness connector for
solenoid, place a jumper wire from
contact 2 to contact 1.
(d) Connect MSD (WP 0005 00) observe
1. If diagnostic code remains active, go to
status of CID 2347 FMI 03.
Test 2.
2. If diagnostic code is no longer active,
solenoid has failed. Repeat this test to
verify solenoid failure. Replace main
control valve (WP 0218 00). Verify new
solenoid corrects problem.
2. Check solenoid energizer circuit for a short
to +battery circuit.