TM 5-3805-291-23-1
TURBOCHARGER ASSEMBLY, AIR LINES, AND OIL LINES REPLACEMENT - CONTINUED
0032 00
REMOVAL - CONTINUED
13.
Loosen clamps (24, 25, and 26) and remove hose (27),
tube (28), and hose (3) from machine.
14.
Loosen two clamps (29) and remove hose (30) and
tube (4) from machine.
427-C0447
CLEANING AND INSPECTION
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to do so may
result in injury or death to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. DO NOT direct compressed air against human skin. Make
sure air stream is directed away from user and other personnel in the area. To prevent injury, user
must wear protective goggles or face shield. Failure to follow this warning may result in injury to per-
sonnel.
N OT E
Before inspection of turbocharger, be sure that inlet air restriction is within specifications for your
engine. Be sure that exhaust system restriction is within specifications for your engine. Refer to Air
Inlet and Exhaust System Inspection (WP 0011 00).
The condition of turbocharger will have definiteeffects on engine performance. Use following inspec-
tions and procedures to determine condition of turbocharger.
0032 00-4