6
TM 5-3805-291-23-2
IMPLEMENT ELECTRONIC CONTROL MODULE (ECM) REPLACEMENT
THIS WORK PACKAGE COVERS
System Configuration Parameters, Copy Configuration from ECM, Remove ECM, Install ECM, Flash Programming,
Copy Configuration (Program ECM)
INITIAL SETUP
Maintenance Level
References
WP 0005 00
Unit
WP 0006 00
Tools and Special Tools
Tool kit, general mechanic's, automotive (Item 90,
Equipment Conditions
Adapter, test (Item 3, WP 0232 00)
Machine parked on level ground (TM 5-3805-291-
10)
Software kit (Item 75, WP 0232 00)
Work tool lowered to ground (TM 5-3805-291-10)
Test set, electronic systems (MSD) (Item 86, WP
Parking brake engaged (TM 5-3805-291-10)
Lockout switch set (TM 5-3805-291-10)
Wrench, torque, dial, 3/8" drive, 300 lb-in. (Item
97, WP 0232 00)
Wheels chocked
Materials/Parts
Drawings Required
Rag, wiping (Item 35, WP 0233 00)
TM 5-3805-291-23P, Figure 53
Personnel Required
Estimated Time to Complete Task
MOS 62B, Construction Equipment Repairer
2.0 hr
CAU T I ON
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened compo-
nent life.
The replacement ECM must have the same serial number suffix or damage to the engine may result.
N OT E
If mission dictates, you may need to remove an ECM from an engine that is not in service. Refer to the fol-
lowing procedure to ensure the configuration parameters match those in the faulty ECM. Be sure to clear
any logged codes if you use a substitute ECM.