TM 5-3805-292-23
0040
CLEANING AND INSPECTION CONTINUED
WARN I N G
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa)
nozzle pressure when drying parts with compressed air. DO NOT direct compressed air
against human skin. Make sure air stream is directed away from user and other personnel
in the area. To prevent injury, user must wear protective goggles or face shield. Failure to
follow this warning may result in injury to personnel.
2. Dry parts with compressed air.
3. Inspect parts for wear, pitting, cracks, or corrosion and replace if necessary.
END OF TASK
INSTALLATION
00040
1. Position bracket (Figure 1, Item 2) on engine and install two bolts (Figure 1, Item 1).
2. Position head (Figure 1, Item 4) on bracket (Figure 1, Item 2) and install two bolts (Figure 1, Item 3).
3. Connect electrical connector (Figure 1, Item 12).
4. Install fitting (Figure 1, Item 10) on head (Figure 1, Item 4).
5. Install elbow (Figure 1, Item 8) on fitting (Figure 1, Item 10).
6. Connect hose (Figure 1, Item 9) to elbow (Figure 1, Item 8).
7. Connect fuel inlet line (Figure 1, Item 5) and fuel outlet line (Figure 1, Item 11) to head (Figure 1, Item 4).
8. Install fuel filter element (Figure 1, Item 6) on head (Figure 1, Item 4) by turning clockwise until snug, then
tighten element an additional 3/4 to 1 full turn.
9. Ensure fuel filter element sediment bowl (Figure 1, Item 7) is securely tightened.
END OF TASK
FOLLOW-ON TASKS
00040
1. Close ROPS (WP 0134).
2. Verify correct operation of machine (TM 5-3805-292-10).
END OF TASK
END OF WORK PACKAGE
0040-3/(4 blank)
