TM 5-3805-298-23-1
0114
Table 1. 1405 Solenoid Valve 5 (Third Gear) Diagnostic Codes - Continued.
0114
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
5. Apply and hold service brake, start
1405-3 Solenoid Valve 5
Diagnostic Code 1405-3 Solenoid
engine, and shift transmission into
(Third Gear) Voltage Is
Valve 5 (Third Gear) Voltage Is Above
third gear forward
Above Normal - Continued
Normal Becomes Inactive
(TM 5-3805-298-10). Using MSD,
Troubleshooting complete.
check for active diagnostic codes
Diagnostic Code 1405-3 Solenoid
Valve 5 (Third Gear) Voltage Is Above
Normal Remains Active Repeat
troubleshooting from the beginning.
NOTE
1405-5 Solenoid Valve 5
(Third Gear) Current Below
Always inspect wiring harness connectors that are involved in the circuit.
Normal
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure and
that all connections are in good condition. If a problem with the
connection is found, correct the problem and verify that this malfunction
or diagnostic code is active before performing this procedure.
Perform open or short-circuit test at each wiring harness connection to
identify the correct wiring harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
DIAGNOSTIC CODE SET CONDITION
Transmission ECM detects an open circuit or low current condition in the solenoid
valve 5 (third gear) circuit.
POSSIBLE CAUSE
Transmission wiring harness high resistance or open.
Lower cab wiring harness high resistance or open.
Solenoid valve 5 (third gear) faulty.
Transmission ECM.
Test Step 1. Check for Active
Diagnostic Codes.
Connect MSD (WP 0008), select
Diagnostic Code 1405-5 Active
Transmission 924H. Apply and hold
Proceed to Test Step 2.
service brake, start engine, and shift
Diagnostic Code 1405-5 Not Active
transmission into third gear forward
Troubleshooting is complete.
(TM 5-3805-298-10). Using MSD,
check for active diagnostic codes
Test Step 2. Test for Faulty Solenoid
Valve 5 (Third Gear).
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Remove right lower cab access
panels (WP 0347).
