TM 5-3805-298-23-2
0140
Table 1. Work Area Vision System (WAVS) Does Not Operate Properly - Continued.
0140
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 7. Inspect WAVS Camera
Work Area Vision System
Lens.
(WAVS) Does Not Operate
1. Turn ignition switch and battery
Properly - Continued
disconnect switch to OFF position
(TM 5-3805-298-10).
WAVS Camera Has Dirt and Debris
2. Inspect WAVS camera (Figure 2,
Obstructing Camera Clean camera
Item 1) for dirt, debris, damage, or
scratched lens.
lens.
Proceed to Test Step 15.
WAVS Camera Scratched or
Damaged Replace camera
(WP 0268).
Proceed to Test Step 15.
Figure 2. Work Area Vision System (WAVS) Camera.
0140
Test Step 8. Test for Open Lamps
Fuse.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Remove lamps fuse from fuse
panel (TM 5-3805-298-10).
Resistance 5.0 Ohms or Less Install
3. Using digital multimeter
lamps fuse (TM 5-3805-298-10) and
(WP 0174), measure resistance
proceed to Test Step 9.
between terminals of lamps fuse.
Resistance Greater Than 5.0 Ohms
Replace lamps fuse (TM 5-3805-298-
10) and proceed to Test Step 12.