TM 5-3805-298-23-2
0155
Table 1. Kickout System Will Not Operate or Operates Improperly Continued.
0155
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 14. Test Voltage to Bucket
Kickout System Will Not
Kickout Position Sensor.
Operate or Operates
1. Turn battery disconnect switch and
Improperly - Continued
ignition switch to ON position
(TM 5-3805-298-10).
2. Set implement disable switch to
unlock position
(TM 5-3805-298-10).
3. Set kickout switch to ON position
(TM 5-3805-298-10).
4. Using digital multimeter
Voltage 18 to 26 V Replace bucket
(WP 0174), test for voltage
kickout position sensor (WP 0297).
between connector N-C2 terminal
Proceed to Test Step 60.
A and terminal C (WP 0012,
Voltage Less Than 18 V Proceed to
Figure 233).
Test Step 15.
Test Step 15. Test Kickout Positioner
Wiring Harness for High Resistance
or Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Remove tiedown strap (Figure 14,
Item 3) from wiring harness
(Figure 14, Item 2) and bracket
(Figure 14, Item 1). Discard
tiedown strap.
3. Disconnect connector LE-C5
(WP 0012, Figure 237) from
connector N-C1 (WP 0012,
Figure 238).
4. Connect jumper wire between
terminal 1 and terminal 3 of
connector N-C1 (WP 0012,
Figure 238).
5. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0174), measure resistance
Remove jumper wire from terminal 1
between connector N-C2 terminal
and terminal 3 of connector N-C1
A and terminal C (WP 0012,
(WP 0012, Figure 238).
Figure 233).
Proceed to Test Step 24.
Resistance Greater Than 5.0 Ohms
Replace kickout positioner wiring
harness (WP 0297).
Proceed to Test Step 60.
0155-23