TM 5-3805-298-23-2
0155
Table 1. Kickout System Will Not Operate or Operates Improperly Continued.
0155
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 55. Test Kickout Positioner
Kickout System Will Not
Wiring Harness for High Resistance
Operate or Operates
or Open.
Improperly - Continued
Using digital multimeter (WP 0174),
Resistance 5.0 Ohms or Less
measure resistance between
Replace bucket kickout position sensor
connector N-C1 terminal 2 (WP 0012,
(WP 0297).
Figure 238) and connector N-C2
Proceed to Test Step 60.
terminal B (WP 0012, Figure 233).
Resistance Greater Than 5.0 Ohms
Replace kickout positioner wiring
harness (WP 0297).
Proceed to Test Step 60.
Test Step 56. Test Lower Cab Wiring
Harness for High Resistance or
Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Disconnect connector LE-C1
(WP 0012, Figure 87) from
connector C-C10 (WP 0012,
Figure 86).
3. Set bucket/fork switch to fork
position (TM 5-3805-298-10).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0174), measure resistance
Proceed to Test Step 57.
between connector C-C22
Resistance Greater Than 5.0 Ohms
terminal 3 (WP 0012, Figure 232)
Proceed to Test Step 59.
and connector C-C10 terminal 1
(WP 0012, Figure 86).
0155-57