TM 5-3805-298-23-2
0155
Table 1. Kickout System Will Not Operate or Operates Improperly Continued.
0155
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. Using digital multimeter
Kickout System Will Not
Resistance 5.0 Ohms or Less
(WP 0174), measure resistance
Operate or Operates
Proceed to Test Step 52.
between connector C-C22
Improperly - Continued
Resistance Greater Than 5.0 Ohms
terminal 1 (WP 0012, Figure 232)
Replace lower cab wiring harness
and connector C-C10 terminal 4
(WP 0291).
(WP 0012, Figure 86).
Proceed to Test Step 60.
Test Step 52. Test Front Frame
Wiring Harness for High Resistance
or Open.
Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0174), measure resistance
Replace carry kickout position sensor
between connector LE-C1 terminal 4
(WP 0297).
(WP 0012, Figure 87) and connector
Proceed to Test Step 60.
LE-C18 terminal C
Resistance Greater Than 5.0 Ohms
(WP 0012, Figure 236).
Replace front frame wiring harness
(WP 0301).
Proceed to Test Step 60.
Test Step 53. Test Lower Cab Wiring
Harness for High Resistance or
Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Disconnect connector LE-C1
(WP 0012, Figure 87) from
connector C-C10 (WP 0012,
Figure 86).
3. Set bucket/fork switch to bucket
position (TM 5-3805-298-10).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0174), measure resistance
Proceed to Test Step 54.
between connector C-C22
Resistance Greater Than 5.0 Ohms
terminal 3 (WP 0012, Figure 232)
Proceed to Test Step 59.
and connector C-C10 terminal 2
(WP 0012, Figure 86).
0155-55
