TM 5-3805-298-23-2
0166
PILOT SYSTEM PRESSURE TEST CONTINUED
5. Remove right lower cab access panels (WP 0347).
6. Remove cap (Figure 37, Item 1) from pilot supply pressure connection (Figure 37, Item 2).
7. Connect other end of hose 177-7861 (Figure 38, Item 2) to pilot supply pressure connection
(Figure 37, Item 2).
Figure 37. Pilot Supply Pressure Connection.
0166
8. Turn battery disconnect switch ON and have an assistant start engine (TM 5-3805-298-10).
9. Have an assistant run engine at low idle (TM 5-3805-298-10).
10. Have an assistant bring the hydraulic oil to operating temperature 140F (60C) (TM 5-3805-298-10).
11. Record the pressure on the 1,450 psi (10,000 kPa) gauge (Figure 38, Item 1).
12. Pressure reading should be 377 25 psi (2,600 170 kPa).
13. Turn ignition switch and battery disconnect switch to OFF position (TM 5-3805-298-10).