TM 5-3805-298-23-2
0187
VALVE COVER BASE REMOVAL CONTINUED
5. Loosen 14 bolts (Figure 5, Item 1) from valve cover base (Figure 5, Item 2) in sequence shown (Figure 5).
6. Remove valve cover base (Figure 5, Item 2) and gasket (Figure 5, Item 3) from machine. Discard gasket.
Figure 5. Valve Cover Base.
0187
END OF TASK
CLEANING AND INSPECTION
000187
Clean and inspect all components IAW Mechanical General Maintenance Instructions (WP 0172).
END OF TASK
VALVE COVER BASE INSTALLATION
000187
NOTE
Ensure gasket is seated correctly in groove in machined face of valve cover base.
1. Install new gasket (Figure 5, Item 3) on valve cover base (Figure 5, Item 2).
2. Position valve cover base (Figure 5, Item 2) to machine.
NOTE
Tighten bolts in sequence shown.
3. Install 14 bolts (Figure 5, Item 1) on valve cover base (Figure 5, Item 2). Tighten bolts in sequence shown
(Figure 5) to 79 lb-in (9 Nm).
