TM 5-3805-298-23-4
0376
REMOVAL
000376
1. Remove rear bolt (Figure 2, Item 1) and washer (Figure 2, Item 2) from windshield washer reservoir bracket
(Figure 2, Item 3).
2. Loosen front bolt (Figure 2, Item 5) on windshield washer reservoir bracket (Figure 2, Item 3).
3. Position windshield washer reservoir (Figure 2, Item 4) aside.
Figure 1. Windshield Washer Reservoir.
0376
WARNING
DO NOT disconnect or remove any hydraulic system hoses, tubes, or fittings unless
engine is shut down and hydraulic system pressure has been relieved. Tighten all
connections before applying pressure. Escaping hydraulic fluid under pressure can
penetrate skin.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before removing
any hydraulic fitting.
Lubricating/hydraulic oils can be very slippery. Immediately wipe up any spills. Failure to
follow this warning may result in injury or death to personnel.
Wear protective eye covering and gloves.
Failure to follow these warnings may result in injury or death to personnel.
4. Disconnect ride control wiring harness connector (Figure 2, Item 9) from ride control solenoid
(Figure 2, Item 8).