TM 5-2420-231-23-3
0284
REMOVAL CONTINUED
11. Disconnect hose (Figure 5, Item 2) from elbow fitting (Figure 5, Item 1) and tee fitting (Figure 5, Item 3).
NOTE
Note position of tee and elbow fittings to aid in installation.
12. Loosen two nuts (Figure 5, Item 8) and remove elbow fittings (Figure 5, Item 1), and O-rings (Figure 5,
Item 7) from tool quick-coupler cylinder (Figure 5, Item 6). Discard O-rings.
13. Loosen nut (Figure 5, Item 4) and remove tee fitting (Figure 5, Item 3) and O-ring (Figure 5, Item 5) from tool
quick-coupler cylinder (Figure 5, Item 6). Discard O-ring.
Figure 5. Tool Quick-Coupler Cylinder.
0284
END OF TASK
CLEANING AND INSPECTION
0284
Clean and inspect all parts IAW Mechanical General Maintenance Instructions (WP 0369).
END OF TASK
INSTALLATION
0284
NOTE
Install lines as tagged and marked during removal.
Remove plugs and caps from hoses and fittings.
1. Install new O-ring (Figure 5, Item 5) and tee fitting (Figure 5, Item 3) on tool quick-coupler cylinder (Figure 5,
Item 6) and tighten nut (Figure 5, Item 4).
2. Install two new O-rings (Figure 5, Item 7) and elbow fittings (Figure 5, Item 1) on tool quick-coupler cylinder
(Figure 5, Item 6) and tighten nuts (Figure 5, Item 8).
3. Connect hose (Figure 5, Item 2) to elbow fitting (Figure 5, Item 1) and tee fitting (Figure 5, Item 3).
