TM 5-3805-255-14
0018
Table 1. Field PMCS for the H100C Loader - (Continued).
LOCATION
ITEM TO
CHECK/
NOT FULLY MISSION
SERVICE
CAPABLE IF:
ITEM NO. INTERVAL
PROCEDURE
Bimonthly
Axle Oil Level
37
WARNING
Check
When servicing this equipment, performing maintenance, or
disposing of materials such as engine/hydraulic oils, coolant,
and fuel, consult your unit/local hazardous waste disposal cen-
ter or safety office for local regulatory guidance.
Engine/hydraulic oils, coolant, and fuel can be very slippery.
Immediately wipe up any spills.
Axle oil may be hot. Use gloves.
Failure to follow these warnings may result in injury to
personnel.
NOTE
Both front and rear axles are checked in same manner.
a. While lubricant is at operating
Class III oil leak is evident.
temperature, park loader on level
ground, completely lower bucket, stop
engine and apply parking brake
b. Remove filler and level check plug.
If lubricant is below plug hole, add
lubricant as necessary to bring level
up to bottom of hole. Refer to Table 6,
Lubricants, in this work package for
grade and quantity of fluid required.
c. Install filler and level check plug.
0018-53