TM 5-3805-255-14
0018
Table 1. Field PMCS for the H100C Loader - (Continued).
LOCATION
ITEM TO
CHECK/
NOT FULLY MISSION
SERVICE
CAPABLE IF:
ITEM NO. INTERVAL
PROCEDURE
Semiannually Axle Oil Change
38
WARNING
When servicing this equipment, performing maintenance, or
disposing of materials such as engine/hydraulic oils, coolant,
and fuel, consult your unit/local hazardous waste disposal cen-
ter or safety office for local regulatory guidance.
Engine/hydraulic oils, coolant, and fuel can be very slippery.
Immediately wipe up any spills.
Axle oil may be hot. Use gloves.
Failure to follow this warning may result in injury to personnel.
NOTE
Both front and rear axles are checked in same manner.
a. Operate loader until normal
Class III oil leak is evident.
operating temperature is reached.
Park loader on level ground,
completely lower bucket, apply parking
brake, and shut down engine
b. Place a suitable container under
axle to catch oil.
c. Remove drain plug and filler and
level check plug.
d. After oil stops draining, install drain
plug.
e. Fill axle up to bottom of filler hole.
Refer to Table 6, Lubricants, in this
work package for grade and quantity
of fluid required.
f. Install filler plug.
g. Operate loader for a short period of
time so oil can work into gears
throughout axle and planetaries
0018-54
