TM 5-3805-255-14
0091
REMOVAL
00091
1. Remove six flywheel bolts (Figure 1, Item 2) and washers (Figure 1, Item 3).
2. Insert two jack screws (Figure 1, Item 1) into tapped puller holes in flywheel (Figure 1, Item 5). Also install two
guide pins (Figure 1, Item 4) on flywheel.
3. Tighten jack screws (Figure 1, Item 1) evenly until flywheel is pulled free of dowel pins on crankshaft.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure that any lifting equipment used is in good condition
and of suitable load capacity. Keep clear of heavy parts supported by lifting equipment.
Failure to follow this warning may result in death or injury to personnel.
4. Attach a suitable lifting device to flywheel (Figure 1, Item 5). Lift flywheel and slide it off guide pins.
Figure 1. Flywheel Removal.
0091
END OF TASK
0091-2
