TM 5-3805-255-14
0102
ASSEMBLY CONTINUED
NOTE
Apply pressure to outer bearing races only.
6. Invert housing (Figure 26, Item 2) and install outer bearings (Figure 26, Item 1) into housing.
Figure 26. Outer Bearings Installation.
0102
7. Invert converter housing (Figure 27, Item 1) and install accessory driven gears (Figure 27, Item 2) into
bearings until snap ring groove near end of shaft is exposed and gear shoulder is bottomed on inner race of
inner bearing. Install new snap ring (Figure 27, Item 3).
Figure 27. Drive Gears Installation.
0102
0102-17