TM 5-3805-255-14
0102
ASSEMBLY CONTINUED
11. Install gear (Figure 29, Item 1) and nut (Figure 29, Item 3) on pump shaft (Figure 29, Item 2). Tighten nut to
45 to 55 lb-ft (51 to 75 Nm).
Figure 29. Pump Drive Gear Installation.
0102
NOTE
Support bearing inner race during pressing operation.
12. Install new snap ring (Figure 30, Item 2) in its groove in output shaft (Figure 30, Item 1).
13. Install output shaft (Figure 30, Item 1) into bearing (Figure 30, Item 3).
Figure 30. Bearing Installation.
0102
0102-19