TM  5-3805-258-24-1 9S00  -CT  INJECTION  VE6HClILAR  ENGINE W1l’N  Scnol.L  FUEL  SYSTEM SPECIFICATIONS WATER  PUMP (1) (2) (3) (4) (5) 011  seal.  Put  engine  oil  on  the  seal  lip.  Assemble   with  the  lip toward  the  bearings. Water  seal  and  ring: a.  Put  water  on  the  seal. b. Install  the seal and ring together in the housing bore, with the  ehiny  face  of  the  ring  outside. Seal  assembly: a.  Remove  the  spring  from  the  seal. b.  Put  water  inside  the  seal  assembly. c.    Install     the    seal    assembly     around    the    shaft,    with    the 7N7843  Installation  Tool,  (the  tool  is  with  the  seal  grout)) until the carbon face makes contect with the shiny f~ce of the  ring  (2). d.  Install   the  spring. Torque  for  bolt  holding the impeller . . . . . . . . . . . . . . . . . . . . . . . . . . . 39 ~ 1 N.m (28 ~ Torque for bolt that secures gear . . . . . . . . . . . . . . . . . . . . 97*7  N,m  (725  lb.  ft.) 1    Ib.ft.) V-BELT  TENSION  CHART WIDTH   TOP BELT  TENSION BELT  TENSION BELT  BEE WIDTH OF  PULLEY “INITIAL”* .llfsE~J** BELT   TOP GROOVE BORROUGHS     GAUGE    NUMBERS GAUGE    READING GAUGE    READING mm in. mm In. N lb. N lb. OLD   GAUGE   NO. NEW  GAUGE  NO. 318 10.72 .422 9.65 .360 445*22 100*5 400  *  22 90*5 BT-33-73F BT-33-95 112 13.69 .547 12.70 .500 534 *22 120  *  5 400244 $ro    *lo BT-33-98-4-16 BT-33-95 5V 15.88 .625 15.24 .800 534  *22 120  *  5 400*44 go~lo BT-33-72-4-I  5 BT-33-72C 11/16 17.48 .888 15.68 .625 534*= 12(3   *  5 4(3(3*44 90210 BT-33-72-4-I  5 BT-33-72C 3/4 19.05 .750 17.53 .690 534  *22 120  *  5 400*44 90210 BT-33-72-4-15 BT-33-72C 15/16 23.63 .938 22s0 .676 534   *  22 120  *  5 4fJ(3~4 go~lo BT-33-72-4-15 BT-33-72C MEASURE    TENSION   OF   BELT   FARTHEST    FROM   THE   ENGINE “’INITIAL”  BELT   TENSION  is  for  a  new  belt. “’USED’   BELT   TENSION  is  for  a  belt  tilch  has  more  than  30  minutes  of  oDerafion  at  rated  sDeed  of  enaine. A10232-1X1 2-14