TM 5-3805-258-24-1
3304 DIRECT INJECTION VEHICULAR ENGINE
SPECIFICATIONS
WITH SCROLL FUEL SYSTEM
(1)
(2)
(3)
(4)
(5)
(6)
OIL PUMP
Bore in bearing of idler
gear . . . . . . . . . . . . . . . . . .
28.600 f 0.048 mm (1.1260 * .0019 in.)
Diameter of shaft for the idler
gear . . . . . . . . . . . . . . . . .
28.512 & 0.013 mm (1.1225 t .0005 in.)
Clearance between bearing and
shaft . . . . . . . . . . . . . . . . . . . . . . .
0.028 to 0.150 mm (.0011 to .0059 in.)
Clearance between gear and body
of pump . . . . . . . . . . . . . . . . . . . . . . . . . .
0.05 to 0.66 mm (.002 to .026 in.)
Diameter of shafta for
pump . . . . . . . . . . . . . . . . . .
22.217 & 0.005 mm (.8747 k .0002 in.)
Bore in bearings for
ahafta . . . . . . . . . . . . . . . . .
22.258 f 0,008 mm (.8763 t .0003 in.)
Clearance between shafts and
bearinga . . . . . . . . . . . . . . . . .
0.028 to 0.053 mm (.0011 to .0021 in.)
Length of
gears . . . . . . . . . . . . . . . .
50.808 f 0.025 mm (2.0003 t .0010 in.)
Depth of bore in pump body for
gears . . . . . . . . . . . . . . . .
50.935 k 0.020 mm (2.0053 k .0008 in.)
Clearance batween end of gears and pump
body . . . . . . . . . . . . . . . . . . . . . . .
0.061 to 0.173 mm (.0032 to .0068 in.)
Length of
gears . . . . . . . . . . . . . . . .
38.070 k 0.025 mm (1.4988 k .0010 in.)
Depth of bore in pump body for
gears . . . . . . . . . . . . . . . .
38.197 + 0.020 mm (1.5038 t .0008 in.)
Clearance between end of gears and pump
body . . . . . . . . . . . . . . . . . . . . . . .
0.081 to 0.173 mm (.0032 to .0066 in.)
Torque for bolt holding drive gear to
drive shaft
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
43 ~ 7 N.m (32 & 5 Ib.ft.)
NOTE: Install the bearings in the cover and body for the oil pump so the
bearing junctions (joints) are in the position shown.
2-12