FUEL SHUTOFF SOLENOID AND FUEL RATIO CONTROL

TM-5-3805-258-24-2 Loader Scoop Type DED 4x4 Articulated Frame Steer 2 1/2 Cubic Yard Bucket (CCE) Airborne/Airmobile Sectionalized and Nonsectionalized Manual
Page Navigation
123

TM 5-3805-258-24-2 ENGINE DISASSEMBLY AND ASSEMBLY FUEL SHUTOFF SOLENOID AND FUEL RATIO CONTROL REMOVE AND INSTALL SHUTOFF SOLENOID 1259-10 NOTE: The fuel ratio control was removed for photo illustration only. Models 950BNS and 950BS are shown. Procedure same for all models. 1. Put identification on wires (2) and disconnect them from fuel shutoff solenoid (1). 2. Remove the bolts and fuel shutoff solenoid (1) from the governor. NOTE: The following steps are for installation. 1. Put the gasket and fuel shutoff solenoid (1) in position on the governor and install the bolts. 2. Connect the wires on fuel shutoff solenoid (1). REMOVE AND INSTALL FUEL RATIO CONTROL 1278-10 1. 2. 3. 4. Disconnect tube (2) from fuel ratio control (1). Remove the two bolts that hold fuel ratio con- trol (1) to the governor. Make sure the stem on the fuel ratio control is disengaged from the lever in the governor. Re- move fuel ratio control (1) from the governor. Inspect and make a replacement if necessary of the-screen assembly and three O-ring seals on the governor housing and O-ring seal on the fuel ratio control. NOTE: The following steps are for installation. 5. Put fuel ratio control ( 1 ) in position on the governor. Make sure the stem fits into the (slot) groove in the lever. Install the bolts. 6. Connect the tube assembly to the fuel ratio control. 7. Make an adjustment to the fuel ratio control See TESTING AND ADJUSTING. 5-80

Privacy Statement
Press Release
Contact