ASSEMBLE ROCKER SHAFT

TM-5-3805-258-24-2 Loader Scoop Type DED 4x4 Articulated Frame Steer 2 1/2 Cubic Yard Bucket (CCE) Airborne/Airmobile Sectionalized and Nonsectionalized Manual
Page Navigation
169

ENGINE TM 5-3805-258-24-2 DISASSEMBLY AND ASSEMBLY ROCKER ASSEMBLE ROCKER SHAFT 1102–16 1. Install rocker arms (5), brackets (l), washers (4) and springs (2) on the rocker shaft. 2. Install rear support bracket (6) on rocker shaft. Make sure hole in rear support bracket is in alignment with hole in rocker shaft. 3. Put pin (3) in position in the bracket. SHAFT 4. Install pin (3) through bracket and shaft with a hammer. 5. Pin (3) must extend 9.60 mm (.378 in.) above the bracket. 6. Install O-ring seal (7) in the rear support bracket. Install rocker arm (8), the original number of washers, spring, washer and retainer ring on the rocker shaft. 7. Install the front support, rocker arm, original number of washers, spring, washer and retainer ring on the rocker shaft. 8. Install the plugs in each end of the rocker shaft if they were removed. end by: a) install rocker shaft and push rods 5-123

Privacy Statement
Press Release
Contact