ENGINETM 5-3805-258-24-2DISASSEMBLY AND ASSEMBLYCYLINDER HEAD9. Fasten a hoist to cylinder head (11). Removethe bolts and cylinder head (11) from the en-gine. The weight of the cylinder head is 61 kg(135 lb.).CAUTIONDo not put the cylinder head down on a flatsurface. This can cause damage to the fuel in-jection valves.INSTALL CYLINDER HEADNOTE: Always install a new1100-12gasket between thespacer plate and cylinder block-before the cylinderhead is installed. See REMOVE SPACER PLATE.1.2.3.4.5.6.7.8.Thoroughly clean the spacer plate and bottomsurface of the cylinder head. Install a new headgasket, water ferrules (1) and the O-ring sealon the hollow dowel.Install a new gasket on the water inlet elbow.Fasten a hoist to cylinder head and put it inposition on the cylinder block. Make sure thecylinder head is in alignment with the dowels inthe cylinder block.Put 2P2506 Anti-Seize Compound Thread Lu-bricant on all the head bolts and rocker shaftbolts. Install the head bolts and washer thathold the cylinder head in place but do nottighten at this time.Remove the bolt from the lifting bracket andconnect wire harness (2) to it. Install the bolt onthe lifting bracket.Connect clip (3) to the cylinder head.Install tube assemblies (4) and (6) to the engineas shown.Connect clip (5) to the cylinder head.5-125
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business