TM 5-3805-258-24-2
ENGINE
DISASSEMBLY AND ASSEMBLY
SPACER PLATE
REMOVE SPACER PLATE
1221-11
start by:
a) remove cylinder head
1. Remove sixteen water seals (1) and one O-ring
seal (3) from spacer plate (2).
CAUTION
Do not cause damage to the dowels as the
spacer plate is removed.
2. Remove spacer plate (2) from the engine block.
3. Remove O-ring seal (5) and gasket (4) from the
engine block.
INSTALL SPACER PLATE
1221-12
1. Thoroughly clean the spacer plate and cylinder
block surfaces.
2. Put a new gasket (3) and O-ring seal (2) in
position on dowel.
3. Put spacer plate (1) in position on the cylinder
block.
CAUTION
Both surfaces of the spacer plate, top of cylin-
der block and both sides of the spacer plate
gasket must be clean and dry. Gasket adhesive
or other substances must not be used on these
surfaces.
4.
5.
Install new water seals (4) and O-ring seal (5)
in the spacer plate.
Check the cylinder liner (projection) height.
See INSTALL CYLINDER LINERS.
end by:
a) install cylinder head
5-130
