ENGINETM 5-3805-258-24-2DISASSEMBLY AND ASSEMBLYCYLINDER HEAD4. Put clean engine oil on the valve stems. Installthe valve, spring and rotocoil in the cylinderhead.WARNINGTo prevent possible personal injury, make surethe locks are in their correct position on thevalve stem when the compressor is released.5.6.7.8.9.10.11.12.Put tooling (C) in position on the valve springand put the spring in compression. Use tooling(D) to install the locks on the valve stem.Remove tooling (D) and hit the top of the valvewith a plastic hammer to be sure the locks are intheir correct position on the valve.Do Steps 4, 5 and 6 again for the remainder ofthe valves.Install brackets (2) for the fuel injection lineclamps on the cylinder head.Put 5P3413 Pipe Sealant on the threads ofwater temperature sending unit (3) and installthe sending unit in the cylinder head.Install lifting brackets (4) on the cylinder head.Use tool (E) to install carbon dam (5) on thefuel injection nozzles. Install seal (6) on thefuel injection nozzles.Put fuel injection nozzles (7) in position in thecylinder head and install the bolt that holdseach nozzle in place.end by:a) install cylinder head5-129
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business