TM 5-3805-262-103-7. lNSPECTION (CONT)g.LoaderBucketAssembly(Cont).h.BucketCuttingEdgeAssemblies.NOTEIf any of the following conditionsare seen,notify organizationalmaintenance (must be corrected).(1)(2)(3)(4)(5)(6)(7)three inches by operating LIFTARM control lever in RAISEthen returning it to NEUT.Inspect clam cutting edge for breaks,cracks, or nicks.Start engine and operate at idlespeed.Raise bucket off ground two orposition. Open clam by operating CLAM control leverin OPEN until clam is opened just enoughfor you to visually check blade cuttingedges. Return CLAM control lever to HOLDposition.Check blade cutting edges for cracks, breaks, and nicks.Close clam and lower bucket to ground.Turn off engine.3-39
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
