TM 5-3805-262-10
2-17. OPERATING PROCEDURES (CONT)
c. Stopping the Loader (Cont).
(6)
(7)
Turn ignition key switch to off position.
Pull out SHUT OFF control. When engine has
stopped, push shut off control completely in.
d. Operating the Loader.
(1) Excavating.
Operating on a hillside can be
ground , etc., change ground
determine if your machine can
ramp.
dangerous. Rain, snow, loose gravel, soft
conditions. Only you, the operator, can
be safely operated on any hillside or
Before you operate on any hillside or ramp, always select low range and
never coast down hill with transmission in neutral (N). To do so could
cause you to lose control of loader and roll over causing loss of life
or serious injury and extensive property damage.
(a) Use LIFT ARM control lever to raise bucket
ground.
approximately 12 inches above
2-54
