TM 5-3805-262-203-30. ENGINE TROUBLESHOOTING (CONT)MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTION2. ENGINE HARD TO START OR WILL NOT START (NO EXHAUST SMOKE) .S t e p 1 . O p e n r a d i a t o r g r i l l e a t r e a r o f l o a d e r.Connect STE/ICE power cable W5 connector P1 to VTM J1.Check that VTM PUSH ON/PULL OFF switch is in OFF position.Connect power cable W5 red clip lead to loader battery positive postand black clip lead to loader battery negative post.Remove engine left side panels (page 9-14).d r i v e .Loosen and disconnect tachometer cable nut from tachometerInstall STE/ICE pulse tachometer in loader tachometer drive.Connect transducer cable W4 connector P1 to VTM J3.Connect transducer cable W4 connector P2 to pulse tachometer.DO STE/ICE confidence test (TM 9-4910-571-12&P).At VTM, dial 60 into TEST SELECT and press and release TEST.When UEH appears on VTM display, dial 22 into TEST SELECT and pressand release TEST.Be sure that fuel SHUT OFF control is pulled completely out.Dial 10 into TEST SELECT and press and release TEST.Crank engine for 15 seconds using ignition key switch and watch VTMdisplay. Be sure to return ignition key switch to off position aftercranking .VTM display should indicate 200 rpm minimum.a. If cranking speed is 200 rpm minimum, go to step 2 below.3-203
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business