TM 5-3805-262-203-26. SIGNALING DEVICES TROUBLESHOOTING (CONT)MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTION2. TURN SIGNALS DO NOT OPERATE.S t e p 3 . ( C o n t ) .a. If multimeter does not indicate continuity, replace turn signalswitch (page 12-8).b. If multimeter does indicate continuity, replace violet wirebetween flasher and turn signal switch.Step 4. Reach up beneath right instrument panel and disconnect connectorfrom rear of vehicle lights switch.Connect multimeter between pins F and J of vehicle lights switchconnector.Ensure that main switch lever of vehicle lights switch is in eitherSER DRIVE or STOP LIGHT position.Multimeter should indicate continuity.a . I f m u l t i m e t e r i n d i c a t e s c o n t i n u i t y , r e p l a c e f l a s h e r ( p a g e 1 2 - 8 ).b. If multimeter does not indicate continuity, remove rightment panel (page 5-48) and replace vehicle lights switch5 - 5 3 ).3. A TURN SIGNAL LAMP DOES NOT OPERATE.Step 1.Replace turn signal lamp assembly bulb (page 12-16).If lamp still does not operate, go to step 2 below.Step 2. Remove turn signal switch cover (page 12-7).i n s t r u-(pageConnect multimeter across violet wire terminal and light blue wiret e r m i n a l.Set turn signal switch lever to position for left turn signal.Multimeter should indicate continuity.Connect multimeter across violet wire terminal and white-blue wiret e r m i n a l.Set turn signal switch lever to position for right turn signal.Multimeter should indicate continuity.a. If multimeter does not indicate continuity, replace turn signalswitch (page 12-8).b. If multimeter does indicate continuity, perform continuity checkof wire between lamp assembly that is not operating and switch.If continuity not obtained, repair wire (page 12-8). If continu-ity obtained, replace lamp assembly (page 12-17).3-199
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business