TM 5-3805-262-20
3-33. STARTING SYSTEM TROUBLESHOOTING (CONT)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. STARTER DOES NOT CRANK (STARTER SOLENOID DOES NOT CLICK) (Cont).
S t e p 2 . ( C o n t ).
a. If VTM display was not over 18 volts while cranking engine, go
to page 3-286, battery system troubleshooting, MALFUNCTION 2.
b. If VTM display was over 18 volts while cranking engine, go to
step 3 below.
Step 3.
Turn ignition key switch to on position.
Place vehicle lights switch in SER DRIVE position.
S e r v i c e d r i v i n g l i g h t s a n d t a il
Turn ignition key switch to off
a . I f a t l e a s t o n e l i g h t i s o n ,
b . I f a l l l i g h t s a r e o f f , g o to
lights should be on.
p o s i t i o n .
go to step 6 below.
step 4 below.
Step 4.
Remove engine left side panels (page 9-14).
Move red test clip of test probe cable W2 to top terminal of loader
30 ampere circuit breaker and black test clip to battery negative
post .
Press and release TEST button.
VTM should display 24 volts.
3-267
