TM 5-3805-262-203-33. STARTING SYSTEM TROUBLESHOOTING (CONT)MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTION1. STARTER DOES NOT CRANK (STARTER SOLENOID DOES NOT CLICK) (Cont).S t e p 6 . ( C o n t ) .a. If VTM displays 24 volts, go to step 7 below.b. If VTM displays zero, check white wire connection between neu-tral start switch and ignition key switch connector START termi-nal. Repair or replace wiring or connector as necessary (page5-168 or 5-174).If wiring and connector are okay, remove right instrument panel(page 5-48) and replace ignition key switch (page 5-53).Step 7. Move red test clip of test probecable W2 to neutral start switchterminal to which violet-blackwire is connected .Press and release TEST button.Check that transmission controllever is in N position.Crank engine while watching VTMd i s p l a y.VTM should display 24 volts.a. If VTM displays 24 volts, goto step 8 below.b. If VTM display is zero, refer to page 3-95, MALFUNCTION 6.Step 8.Move red test clip of test probe cable W2 to starter relay terminalto which violet-black wire is connected (second terminal from left).3-269
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business