TM 5-3805-262-203-33. STARTING SYSTEM TROUBLESHOOTING (CONT)MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTION1. STARTER DOES NOT CRANK (STARTER SOLENOID DOES NOT CLICK) (Cont).Step 8.Step 9.(Cont).Move black test clip of test probe cable W2 to starter relay termi-nal to which ground wire is connected (third terminal from left).Press and release TEST button.Check that transmission control lever is in N position.Crank engine while watching VTM display.VTM should display 24 volts.a. If VTM displays 24 volts, go to step 10 below.b. If VTM displays zero, go to step 9 below.Move black test clip of test cable W2 to battery negative post.Press and release TEST button.Check that transmission control lever is in N position .Crank engine while watching VTM display.VTM should display 24 volts.a.b.3-270If VTM displays 24 volts, check ground wire connection betweenstarter relay terminal and mounting capscrew. Tighten connec-tions or repair wire as necessary.If voltmeter indicates zero, check wiring connection betweenneutral start switch and starter relay terminal to whichviolet-black wire connected. Repair or replace wiring as neces-sary (page 5-174).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
