TM 5-3805-262-203-33. STARTING SYSTEM TROUBLESHOOTING (CONT)MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTION2. STARTER CRANKS CONTINUOUSLY (Cont) .S t e p 1 . ( C o n t ).Dial 89 into TEST SELECT.Connect test probe cable W2 red test clip to black test clip.Press and hold TEST until CAL appears on display then release TEST.Wait for offset value to appear on display. Offset value should bebetween -6.8 to +6.8. If it is not, STE/ICE is defective (refer toTM 9-4910-571-12&P).Connect test probe cable W2 connector P1 to VTM J4.Connect test probe cable W2 red testclip to starter solenoid S terminal andb l a c k t e s t c l i p t o b a t t e r y n e g a t i vepo St .Press and release TEST button.VTM should display zero.Turn ignition key switch to on position.VTM should display zero.a. If VTM displays zero, replace starter(page 5-16).b. If VTM displays 24 volts, go to step2 below.3-272
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business