TM 5-3805-262-205-6. AUXILIARY STEERING ELECTRiCAL SYSTEM MAINTENANCEa. Relay Socket Assembly.This task covers removal, cleaning, inspection, repairand installation of relay socket assembly and its associated wiring.TOOLS: No. 1 Common Organizational Maintenance Tool KitCombination box and open end wrench setScrewdriverE l e c t r i c a l r e p a i r t o o l k itB l i n d r i v e t t o o l k itCraftsman’s knifeE l e c t r i c d r i llMultimeterSoldering gun, 25 wattsElectric heat gunS o f t b r i s t l e b r u shMATERIALS/PARTS: Clean cloths (Appendix C, item 1)Cleaning solvent P-D-680 (Appendix C, item 2)Detergent (Appendix C, item 3)Insulation tape (Appendix C, item 5)Silicone rubber adhesive (Appendix C, item 8)Isopropyl alcohol (Appendix C, item 15)Solder (Appendix C, item 16)Electrical cleaner (Appendix C, item 19)Electrical sealer (Appendix C, item 20)Tie strap (FSCM 06383 PN SST2S0)Heat shrink tubing (FSCM 22770 PN 708-3804)NOTEPRELIMINARY PROCEDURE: Battery ground cable disconnected (page 5-148).REMOVAL (SHEET 1 OF 2)(1)(2)( 3)(4)(5)(6)In operator’s compartment, below left-hand instrument panel, disconnectwire (1) terminals from front wiring harness terminal and connector (2)by grasping with fingers and firmly pulling apart. Remove wire (1).Disconnect two black-white wire terminals from connector (2) by graspingwith fingers and firmly pulling apart. Remove connector (2).Disconnect two flow switch wiring harness terminals from relay socketassembly (10) wire terminals by grasping with fingers and firmly pullinga p a r t.At rear of buzzer, tag relay socket assembly (10) white-black wire,remove two screws (3), and disconnect two wire terminals from buzzer.At left side plate, loosen and remove two nuts (4), lock washers (5),screws (6), and lock washers (7). Lower relay socket assembly (10) tocompartment floor.Disconnect relay socket assembly (10) black wire and wire (8) terminalsfrom screw (6). Remove wire (8).5-76
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business