INSTALLATION (SHEET 3 OF 3)
k .
l .
m.
n .
o .
p .
Connect wiring harness
using two screws (8).
TM 5-3805-262-20
terminals (9) to micro switch (14) NC and COM terminals
At return-to-dig guide rod, install micro switch (5) and secure using two
screws (6), washers (7), lock washers (4), and nuts (3).
Connect wiring harness terminals (2) to micro switch (5) NC and COM terminals
using two screws (l).
Spray all terminals with electrical cleaner and allow to air dry. Then spray
t e r m i n a l s w i t h e l e c t r i c a l s e a l e r.
Adjust return-to-dig control (page 11-17).
Close front access door.
5-75
