TM 5-3805-262-20
5-6. AUXlLIARY STEERlNG ELECTRICAL SYSTEM MAlNTENANCE (CONT)
a. Relay Socket Assembly (cont).
INSPECTION
(5)
( a)
(b)
( c)
(d)
(e)
( f )
(g)
(h)
AND REPAIR (SHEET 3 OF 4)
Inspect relay socket assembly wires for cracked or broken insulation or
broken wire strands. Inspect relay socket terminals and contacts for
cracks, breaks, distortion, or other damage. If any of the above
conditions are seen, replace wire or relay socket as follows:
Unsolder end of wire and disconnect from relay socket terminal.
Loosen and remove nut (19), lock washer (20), screw (22), and washer
(23). Spread clamp (21) and remove from wires.
At relay socket (25) to be removed, tag, unsolder, and disconnect all
remaining wires and component leads from relay socket terminals.
Remove heads from two rivets (24) using electric drill.
Remove relay socket (25) and rivets (24) from bracket (26) and
discard. Remove all loose metal particles using soft bristle brush.
Install new relay socket (25) on bracket (26) using tool and two new
r i v e t s c o n t a i n e d i n b l i n d r i v e t t o o l k i t .
Connect component leads and wires to relay socket (25) as tagged and
s o l d e r.
Install clamp (21) around wires and install on bracket (26) using
screw (22), washer (23), lock washer (20), and nut (19).
5-80
