TM 5-3805-262-20
REPAIR (SHEET 2 OF 3)
( c)
Pull insert with wire end from grommet and cut wire as close to insert
a s p o s s i b l e.
(d)
Strip wire insulation to depth of insert solder well, position wire
end in solder well of insert, and solder .
( e )
Push insert with wire into grommet. Then aline inserts with holes in
connector shell and push grommet with inserts into connector shell
u n t i l s e a t e d .
( f )
Slide connector nut along wiring harness and install on connector
s h e l l .
(g)
Install connector shell in mounting bracket using washer and nut.
(5) Replace friction-type spade and bullet terminals by cutting wire as close
to terminal as possible. Strip 1/4 inch insulation from end of wire tak-
ing care not to cut through wire then crimp new terminal securely onto
w i r e.
(6) Replace fuseholder by cutting wires as close to fuseholder halves as pos-
sible, stripping 1/4 inch insulation from ends of wires, and splicing new
fuseholder wires to harness wires using insulated crimp connectors.
(7) If removed, install wiring harness clamps and new tie straps at locations
noted during removal.
( 8 ) S p r a y t e r m i n a l s a n d c o n t a c t s w i t h e l e c t r i c a l c l e a n e r a n d a l l o w t o a i r
d r y .
5-175
