TM 5-3805-262-20
REMOVAL (SHEET 1 OF 3)
(1)
(2)
(3)
(4)
( 5)
(6)
(7)
Beneath cab deck, remove nut (1) and lock washer (2).
P u l l b a l l j o i n t ( 3 ) f r o m c a b l e l e v e r ( 9 ).
I f n e c e s s a r y, loosen nut (5) and remove ball joint (3) by unscrewing it
from cable assembly (4).
Support clamp assembly (10) and remove two nuts (7) and lock washers (8).
Remove clamp assembly (10), cable lever (9), washer (11), spring (12),
and washer (13) by sliding down off control shaft (23).
Remove lubrication fitting (14).
Remove capscrew (15) and lock washer (16). Remove block assembly (17)
with seal (18) and bushing (19) installed as an assembly by sliding down
o f f c o n t r o l s h a f t ( 2 3 ).
NOTE
Don't remove seal (18) or bushing (19) from block assembly (17) unless
inspection indicates replacement of these parts is necessary.
(8) Inside operator-s compartment, remove two screws (20) and cover (21).
(9) Remove steering wheel (page 8-10).
(10) If necessary, remove knob (22) from control shaft (23).
(11) Remove transmission control shaft (23).
(12) Remove thrust bearing (24).
NOTE
Perform steps (13) through (15) below only if stop (31) or bearing (36)
require removal.
(13) Remove two capscrews (25) and lock washers (26) while supporting mounting
bracket (27). Remove mounting bracket (27) with stop (31) and bearing
( 3 6 ) i n s t a l l e d.
(14) Remove capscrew (28), nut (29), and lock washer (30). Remove stop (31).
(15) Remove two screws (32), nuts (33), lock washers (34), and washers (35);
remove bearing (36).
6-11
