TM 5-3805-262-20
6-1. TRANSMISSION MAINTENANCE (CONT)
b. Control Valve Linkage (cont).
INSTALLATION (SHEET 3 OF 4)
(10)
(11)
(12)
(13)
(14)
If necessary, locate bearing (36) on mounting bracket (27) and secure
using two screws (32), washers (35), lock washers (34), and nuts (33).
Position stop (31) on mounting bracket and secure with capscrew (28),
lock washer (30), and nut (29).
Inside cab, position mounting bracket with assembled parts and secure
using two lock washers (26) and capscrews (25).
Position thrust bearing (24) on control shaft (23) then install control
shaft through bearing (36) mounted on mounting bracket (27). Check that
notch located on control shaft is centered on stop (31).
Install knob (22) on control shaft (23).
Position cover (21) and secure with two screws (20).
6-16
