TM 5-3805-262-34
4-3. TRANSMISSION MAINTENANCE (CONT)
d. Forward Clutch and Planetary Group (Cont).
DISASSEMBLY (SHEET 2 OF 2)
(5) Use screwdriver to remove re-
taining ring (6) securing re-
(17).
verse ring gear (5) to forward
clutch carrier (17).
(6)
Remove reverse ring gear (5)
from forward clutch carrier
NOTE
Don't disassemble forward
clutch carrier (17) and
associated parts (13 thru 16)
unless inspection indicates
these parts are damaged. Refer
to cleaning, inspection, and
repair for repair/replacement
of these parts.
CLEANING, INSPBCTION, AND REPAIR (SHEET 1 OF 4)
parts is toxic and flammable.
use only in a well ventilated
Dry cleaning solvent P-D-680 used to clean
Wear protective goggles and gloves and
area. Avoid contact with skin, eyes and clothes and don-t breathe
vapors. Do not use near open flame or excessive heat and don’t smoke
when using it. Failure to do so could cause serious injury. If you be-
come dizzy while using cleaning solvent, get fresh air and medical
attention immediately. If contact with skin or clothes is made, flush
with large amounts of water. If contact with eyes is made, wash eyes
with water and get medical aid immediately.
Compressed air used for cleaning purposes will not exceed 30 psi. Use
only with effective chip guarding and personal protective equipment
(goggles/shield, gloves, etc). Failure to do so could cause serious
injury to eyes and possible blindness.
If you hurt your eyes or if a
foreign object is blown into your eyes, seek medical attention
immediately.
(1) Clean all parts using cleaning solvent P-D-680. Dry using compressed air.
4-152
