TM 5-3805-262-34
4-3. TRANSMISSION MAINTENANCE (CONT)
g. Output Shaft (Cont).
REMOVAL (SHEET 3 OF 3)
(10) Remove transfer gear (9) and
spacer (10) from transmission
housing.
(11) Remove and discard oil seal
(11) from transmission housing
using puller.
(12) Using a 3-1/2 inches outside
diameter sleeve bearing on
outer race of bearing (12),
drive bearing from transmission
housing.
(13) Put output shaft (8) in hydrau-
lic press. Install collar as
shown, then press output shaft
from bearing (7).
(14) If necessary, remove plug (13)
from front of transmission
housing.
LEGEND
1. Lock nut
2. Washer
3. O-ring
4. Output flange
5. Oil seal
6. Retaining ring
7. Bearing
8. Output shaft
9. Transfer gear
10. Spacer
11. Oil seal
12. Bearing
13. Plug
4-190
