CLEANING - TM-5-3805-262-34

REMOVAL (SHEET 3 OF 3) - TM-5-3805-262-34_1134

TM-5-3805-262-34 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
1116

TM 5-3805-262-34 CLEANING Dry cleaning solvent P-D-680 used to clean Wear protective goggles and gloves and parts is toxic and flammable. use only in a well ventilated area. Avoid contact with skin, eyes and clothes and don’t breathe vapors. Do not use near open flame or excessive heat and donut smoke when using it. Failure to do so could cause serious injury. If you be- come dizzy while using cleaning solvent, get fresh air and medical attention immediately. If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water and get medical aid immediately. Compressed air used for cleaning purposes will not exceed 30 psi. Use only with effective chip guarding and personal protective equipment (goggles/shield, gloves, etc). Failure to do so could cause serious injury to eyes and possible blindness. If you hurt your eyes or if a foreign object is blown into your eyes, seek medical attention immediately. (1) Clean bearings (7 and 12) by immersing in cleaning solvent P-D-680 and slowly moving up and down. Remove bearings from cleaning solvent and strike larger side of cone against a block of wood to dislodge solidified particles of lubricant. Immerse again in cleaning solvent and repeat above until bearings are clean. Dry using compressed air. Direct air stream across bearing to avoid spinning. Don’t spin bearings when drying; rotate bearings slowly by hand to facilitate drying. After drying bear- ings, lubricate using clean lubricating oil. Keep bearings in a clean area. (2) Clean remaining parts using cleaning solvent P-D-680. Dry using com- pressed air. INSPECTION NOTE Replace an item if inspection indicates need for replacement. (1) Inspect bearings (7 and 12) by rotating and checking that it turns smoothly. Check bearing balls and rollers for flat areas, pitting, scored, scratched, chipped, or cracked races. (2) Inspect transfer gear (9), output shaft (8), and output flange (4) for cracks or chipped, nicked, burred, broken, or missing teeth. (3) Inspect output flange (4) for distortion or thread damage. (4) Inspect remaining parts for distortion, excessive wear, or thread damage. 4-191

Privacy Statement
Press Release
Contact