TM 5-3805-262-344-3. TRANSMISSION MAINTENANCE (CONT)i. ControlValve(Cont).REASSEMBLY(12)(13)(14)(15)(16)(17)(18)(19)(20)(21)(SHEET 2 OF 2)Install clutch cut off spring (15) in its bore. Then, install clutch cutoff valve (14).Put plug (10) in soft jawed vise.Install new seal (12) on piston (13) groove. Install piston with seal inplug (10). Use drive pin punch to push piston down into plug.If available, install cut out cylinder in plug (10). Tighten cylindersecurely.Remove plug (10) from vise and put new gasket (11) on plug. Push and holdclutch cut off valve (14) into body (29) using screwdriver. Install plugand gasket and tighten securely.Put retainer (8) on regulator valve spring (7) and put spring insidetrimmer valve spring (9). Install springs in regulator valve port of body(29).Install trimmer valve plug (6).Put new gasket (5) on plug (4). Install plug and gasket and tighten plugsecurely.Install regulator valve (3) in its bore in body (29).Put new gasket (2) on plug (1). Install plug and gasket and tighten plugsecurely.Be careful in following step not to put too much pressure on controlvalve body (29). To do so could distort body causing cracks or otherdamage.(22) Put control valve body (29) in soft jawed vise. Tighten all plugs secure-ly, and, if available, install clutch pressure switch, back up alarmswitch, and neutral start switch and new gasket. Change position of bodyin vise as necessary to tighten and install these parts.(23) Apply thread sealant to oilseal mounting area of body (29)bore. Put new oil seal (23) inposition on valve spool (24)and start into body bore. Using1-1/4 inches outside diametersleeve and hammer, push oilseal into body.(24) Install control valve ontransmission housing (page3-343).4-212
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
