TM 5-3805-262-34
2-8. TRANSMISSION TROUBLESHOOTING (CONT)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4. LOSS OF POWER (Cont).
Step 2. (Cont).
b. If pressure gage indication was less than 40 psi, spring in
torque converter pressure regulator is broken or damaged.
Replace transmission (page 3-330) and forward to general support
maintenance.
c. If pressure gage indication was 40 psi, disconnect pressure gage
hose from transmission port.
Install converter temperature
sender in transmission port (refer to TM 5-3805-262-20). Go to
step 3 below.
Step 3.
At right side of transmission, locate fitting connected to inlet of
oil cooler. Marking TO COOLER is beside fitting. Loosen and discon-
nect hose fitting from this fitting.
Connect flowmeter inlet hose to fitting from which oil cooler hose
was disconnected.
Connect flowmeter outlet hose to oil cooler hose disconnected from
fitting.
2-93
