TM 5-3805-262-34SHEET 13 OF321Tell assistant to release accelerator pedal and shut down engine. Thenhave assistant press accelerator pedal fully.Check that governor control lever rests against no-load governed speedadjustment screw. If necessary, adjust throttle linkage (refer to TM5-3805-262-20) until control lever contacts adjustment screw. Thentell assistant to release accelerator pedal.Recheck engine no-load governed speed, steps 1 and 2 above. Go to step6below if tachometer does not indicate specified no-load governedspeed.Cut, remove, and discard wire seal, then pull plastic cap from nut andadjustment screw.To increase no-load governed speed, loosen nut and turn adjustmentscrew 1/2 turn counterclockwise. To decrease no-load governed speed,loosen nut and turn adjustment screw 1/2 turn clockwise. Then holdadjustment screw and tighten nut.Recheck engine no-load governed speed, steps 1 and 2 above. If neces-sary, readjust no-load governed speed adjustment screw, step 7 above.Repeat until tachometer indicates specified no-load governed speed.Position plastic cap over adjustment screw and nut, and install newwire seal. Pull wire into tight loop and crimp seal to secure plasticcap.3-15
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business