TM 5-3805-262-34
13-1. ENGINE MAINTENANCE (CONT)
(2)
Detailed Procedure (Cont).
INSTALLATION (SHEET 1 OF 6)
(a)
(b)
(c)
Remove plug from bottom of
torque converter housing.
Rotate transmission flex
plates to position one
mounting hole directly
at bottom.
Rotate engine flywheel to
position one mounting hole
directly at bottom.
When using chain hoist to remove or install parts, be sure chain hoist
is securely fastened to the part and that all slack in chain is taken
up. Failure to do so could cause serious injury due to the part falling
on you.
If you are injured
immediately.
(d) Connect lifting fixture
cylinder head studs and
Check that all hoses, lines,
by falling equipment, obtain medical aid
and chain hoist to engine at front and rear
take up all slack.
and e-
lectrical leads are clear as engine
is lowered into loader.
If neces-
sary,
reposition hoses, lines, or
electrical leads before installing
engine.
(e) Using chain hoist and lifting
fixture, lower engine into
loader; move engine forward
until positioned against
transmission torque converter
housing.
(f) Insert one capscrew (9) with
lock washer (10) through
flywheel housing opening.
3-30
